Girls Twin Bed Frame – If you are like many people, you have a set of two beds in the house, either left over from children who have grown up and left the house or maybe picked them up from a garage sale. For some reason, the beds sit there. Building a simple wooden frame for a bed requires knowing the dimensions of your mattress and box spring. You can measure the bottom of the spring or use the standard sizes used by the manufacturers. Bed frames can be simple box frames. You can turn it into a large and nice extra-large bed by sliding them together and screwing at each other.
Slide the beds together and hold them in place by tying the ends together or placing heavy objects on the legs or even the use of wooden clamps, if any. Remove mattresses and bedding so you can see and access the joined side rails of the girls twin bed frame. Frames 4 holes spaced evenly apart inside the side rails that are pressed together. The holes should be approximately 2 inches down from the top of the rail and at least 6 inches from the ends of the bed. Drill the holes with the electric drill directly through the two side rails. If the bit is too short, you can always go through one side and then the other.
Clean any sawdust created. Slide the car bolt directly through the two side rails. If it is tight, tighten it in place with a hammer. Slip on the washer and the wing nut. Tighten until it is firm, but do not over tighten. You do not want the wood to crack. Make the 4 screws, washers and wing nuts. Return to place the mattresses and bed use is now larger than normal. There are cases in mattresses that are designed to store two girls twin bed frame, forming a double bed and without a crack in the middle.